#2
|
||||
|
||||
Well, lets see here. It all depends on the motor your running. Li polys tend to be more expensive the Li ions, Li ions are for lower drain motors, or motors above 30t, Lipolys are for HOT motors, or motors below 30t. Li polys offer better performance than any other battery, but, Li ion is not to far away.
You need an advaced board to run Li polys, and for Li ions, there is little to know modification. Later, RedSXmodder |
#3
|
||||
|
||||
i use the ions there grt gives u enough power
__________________
Scion Tc evo stock Skyline GTR switchblade chasis,am fatboy motor,bearings, liths, nos kit, tight steer, x2-3 fets, awd,cf shaft 350Z drifter ,bearings , liths, fets, Civic stock with tight turns NSX drag liths, bearings, fets, all have wild kits with lighting sweeeeeettttttt!!!!! |
#4
|
||||
|
||||
i plan on leaving my stage 2 alone for a while. But in the future i plan to get the ball bearing can from atomicmods and maybe have someone wind up my motor to maybe 40t. So should i get the li ions? What wouyld i have to mod besides the motor wires. One more ?, do i get the car lithium ion propack s2? or is there one for an evo truck. ps i have an f150 with bearings and awd.
Last edited by monstertruggy; 02-12-2007 at 10:09 AM.. |
#5
|
|||
|
|||
umm get cylindrical lith ions. AA size. and get a charger. on eBay, there are some for like 20.00 with the charger.
|
#6
|
||||
|
||||
You don't need an advanced board to run Lithium Polymere batteries. The ones used for xmoding are actaully a Lithium Ion/Polymere Hybrids. Anyway.
LiPo supply more "C", or more current to the motor(s). They are also more expensive, and are somewhat more dangerous. They can explode if overchargered, punctured, or worse..... Cylindrical Li-ions (AA or AAA) ussually have a little pocket at one end that ruptures and cuts power and keeps them from exploding, making them somewhat safer... Li-ions supply less current, but they are less costly, and fit Gen1's better, and the AAA's fit the Evo and EvoT's better. Both need a specialty charger.... Li-ion is for mild motors and mods. Li-Poly is for "hot" motors and mods, as they supply more current... Hope that helps.
__________________
After a thousand years of oppression,
Let the berserks rise again, Let the world hear these words once more: "Save us, oh lord, from the wrath of the Norsemen" |
#7
|
||||
|
||||
Quote:
__________________
Approved Service Provider XMS Rules Buy/Sell/Trade Rules My XMODS Proud member of Team NCXR WANTED: Gen. 1 cf Chassis Upgrade (just parts from the upgrade will do fine) |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|