Zen Nihon GT Sensyuken Lancer Evolution - Page 2

Bananabrain · #21 08-18-2009, 10:08 PM

Quote:

Originally Posted by sparky

clear coat it with the scars, or repaint then clear coat???

Dude if you clear coat it with the scars, then it would be awsome becasue you are adding more realism to it.

Also it will make it look like you painted it that way too.

sparky · #22 08-25-2009, 04:15 AM

Well after installing a new upgraded motor into the Evo, it was running really fast for only about 10 seconds before the FET started glowing red hot and melted a section of the car...

DRFTKO · #23 08-25-2009, 04:30 AM

Quote:

Originally Posted by sparky

Well after installing a new upgraded motor into the Evo, it was running really fast for only about 10 seconds before the FET started glowing red hot and melted a section of the car...

Ouch, sorry to hear about that unfortunate event. Do you have any pics of the damage? What motor were you running?

Bananabrain · #24 08-26-2009, 08:58 AM

bummer, i have had that happen before not fun & not pretty, hope you can get it fixed & up and running again.

sparky · #25 08-27-2009, 04:10 AM

didnt have any pictures of the damage. I had built my own from the Atomic mods bare case with the high power magnets, stage 2 armature, vented brushes. I had just put in fresh charged batteries and ran the motor with the car in my hand, all was good. So I put her on the ground, ran it full blast all or nothing. Within about 10 seconds it started smoking a little, and then alot and then the car stopped and smoked more. Lucky me I didn't have the body on the chasis cause it would not of been pretty. I will get a picture up of the carnage next to the new xmod.

sparky · #26 09-04-2009, 02:21 AM

Here is the new ride:

I transfered over all the goodies from the Evo to the 370z

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)