![]() |
#2
|
||||
|
||||
![]() If you know how, make a custom rear clip holder and a custom front clip.
Here's a tut: http://www.xmodworld.com/modules.php...wtopic&t=20934
__________________
ಠ_ಠ I see what you did there
Last edited by taiwanesekid05; 03-18-2008 at 12:11 AM.. |
#4
|
||||
|
||||
![]() Okhay, here are the steps:
1. Flip the mini-z body upside down so that you are looking inside the body. 2. Pull of the tabs for mounting of the sides. 3. sand that area down. 4. See if your xmod clip will fit into the hole up front for the mini-z clip. 5. If so, use that (xmod) clip. If not, see if the mini-z clip will fit on your gen.1 (It should because it fits on my evo) 6. Take some puddy and a gen.1 rear clip. 7. Attach the clip to the window/roof or the puddy. 8. Tada, you have succesfully put a mini-z body onto a gen.1 xmod. p.s. if you need more help or more specific instructions, pm me. |
#5
|
||||
|
||||
![]() Thanks for the link taiwanesekid05!
|
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|