Mini-z body to Xmod Chassis......HOW?

[xmodsunlimited]

So I am planning on getting this or this in a different color- http://cgi.ebay.com/ws/eBayISAPI.dll...ht_3203wt_1165

How do I adapt this to a xmod evo chassis.
I could not find any tutorials on how to do it.

any suggestions?

Thanks

[Kot]

really? there's been countless tutorials.
typically you should use styrene to mount it. seeing that its a hatch back, maybe you can glue styrene and what not to the insides above the wheel arches rather than the roof, and then do some cutting and more gluing with an evo clip, and voila.

theres also a screw method but i dont remember where to locate a picture for it.

[All_Xmods]

I agreed. There are numerous tutorial out there.

Here is a simple one that I've been using;
1. Find a matching front clip from your xmod collection, (RSX, and 350Z works well with the short front bumper shells).
2. Cut or unglue (if you plan on reusing the shell on your MINI Z chassis later on) the mounting white tabs from your Mini Z shells.
3. Take the battery cover from the dummy chassis your Z is came with. Cut it into a size that will fit in your Z Rear end (trunk area)
4. Drill a bunch of hole on the center line of this battery cover piece.
5. Mount this cover piece by screwing it into the Spoiler of the Z body from inside the trunk. (I was able to do this for the Viper and the RX7).
6. Finally, using a shaved evo (or gen1, depends on your chassis) rear clip and use trial and error method to mount it up to the hole you drilled in step four.

This is a cheap way to do it with all part you may have already.

[RCrally]

here

http://mini-zracer.com/forums/showthread.php?t=31868

http://www.xmodsource.com/forum/showthread.php?t=16744