#1
|
|||
|
|||
Does Not Turn Well To The Right, Problems in turning with my Xmod
Hello,
I just buy my first Xmod but I have a problem to run with him because I can not have a good turn to the right!... Can anyone give me some tips for that? Thanks, |
#4
|
|||
|
|||
nope, and nope, if it is an evo than just loosen the skid plate
__________________
WHAT'S IN THE GARAGE - 04' Mustang - Red - 07' 'The Boss' Mustang Gt - Yellow & Black - 89' RX-7 Fc36 - Initial D Takahashi RedSuns - White - 69' Fire bird - Jet Black - TC - Pearl White - Nsx - Yellow - Lancer Evo VIII MR - Grey - 01' - Civic Hatchback - Metalic Purple - 07' F-150 - Truckin' Edition - Red - Black |
#5
|
|||
|
|||
Hello All,
Thanks for the tips. 1 - "it is possible that the controler is faulty. also, you could try centering the servo." I already did try to do that with no results. 2 - "Has it been 30 days since you bought it? I suggest getting it replaced." I live in Portugal and bought my Xmod on a visist to German. 3 - "nope, and nope, if it is an evo than just loosen the skid plate" No it's no a evo. It's a Classic (Black Honda Civic). I did try to release a little bit the servo and get a little (little, little) better. I think that I'm going to try this: http://s6.invisionfree.com/Infernal_...showtopic=6512 What do you think? Thanks, |
#7
|
|||
|
|||
ok so its a gen.1 and just do tight turns mod..
|
#9
|
||||
|
||||
Quote:
__________________
Look look, they hearts racin'...They start chasin'...But I'm so fast when I blow past...That they can't BREATHE ,',',',',',',CrUnK RiDaZ....http://www.freewebs.com/crunkridaz',',',',',',', |
#10
|
|||
|
|||
Thank you all,
I also get this tip: http://s6.invisionfree.com/Infernal_...showtopic=3664 I will check this and also your tip and try something tomorrow or next monday. I will give some news. Thanks again, |
#11
|
|||
|
|||
For F150 K!ller: you mentioned in one of the forums about tight turns mods. do you have anymore info on this? i was told i just need to replace some resistor in the servo for the gen 1 xmods. if so do you know what size resistors do i use because i have a bunch of resistors here at home.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|