#42
|
|||
|
|||
I know a guy selling a mint one he has almost 100 mods new and used also tons of parts.that is where I got both of mine.also he is throwing in a Gen AWD kit and GPM front shaft for the diff gear u can' find them anymore
|
#43
|
||||
|
||||
@ xmdrifter believe it or not I have 2 nsx both i got off ebay 1 i got for $30 free shipping and another for $20 plus S&h both were it good condition . The picture i posted are just a few compared to my full collection. i been laggin on pics .
|
#44
|
|||
|
|||
well my xmod street got some parts drop kit , suspension , AWD & bearings .next will be F&R GPM hubs and cvd's.
Also got my new gen1 mustang parts that i have are AWD, bearings still in the mail,GPM front cvd rear shafts and front part that goes threw the gear also bought the carbonfiber chassis parts should be here friday. |
#49
|
|||
|
|||
some gen 1 parts came in ...I forgot how crapy the gen 1 turn shipping it aout to atomic for tite turnz stacks and center the servo.
just called atomic and they do not work on xmods anymore.I din't under stand why not if there looking for xmod parts. Last edited by yamar6; 08-20-2012 at 01:03 PM.. |
#53
|
|||
|
|||
When I need something done that I either can't do or just dont want to risk with my occasional clumbsiness, I take my cars to a local hobby shop. Theres two nearby me and one doesn't work on small rc's. so I take it to the smaller homier one (if that made any sense at all)
|
#55
|
||||
|
||||
you would have to search online, or find someone that is willing to sell it to you. If you cant find it search for the body clip compatiibility, I believe the r8 is a medium clip and a Xmods Street Skyline Front Clip will work
|
#56
|
|||
|
|||
For the awd gen 1 spur gear that is installed in the front of the vehicle just take a rear cone gear and shave away the teeth on the circular end. that should act as a replacement for your awd front spur gear. For the tight turnz go to radioshack to buy the resistors?
|
#57
|
|||
|
|||
evo street how she sits now...GPM F@R knuckles, F@R cvd's, Motor heat sink and all radio shack upgrades.1problem im having is the rear gpm screws are a little longer then the stock ones so the car sit high im woundering if i can put washers on top of the shocktower wher the top screw goes to the knuckle.Do they make washers that small.
Update found washers that fit now i can make the chassis lower then having the drop kit.I put the front drop kit back on and put one washer in the rear to even the car out.Also i had to buy a new chassis because i tried switching the crystal and screwed it up.The car runs perfect it turns both ways in a small circle.This is the best xmod i had so far and i had a few. Last edited by yamar6; 11-25-2012 at 09:31 AM.. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|