#1
|
||||
|
||||
spacers?
i'm in the process of making another h2 crawler, but i took of the motor cradle, one of the spacer/bearing fell off one of the gears. does anyone no where i can get another one of those? i need one, the gears won't even move when i put the cradle back on, so please help me with this problem.
__________________
IN NEED OF MONEY FOR MRC!!!! |
#2
|
||||
|
||||
have you tried looking lol.if have a 4wd anywhere that is not in use use the bearing from it
|
#3
|
||||
|
||||
yah i hav looked, i don't have another 4wd , i just want this one to be functional again
__________________
IN NEED OF MONEY FOR MRC!!!! |
#4
|
||||
|
||||
do u have any other cars or trucks
|
#6
|
||||
|
||||
lets see lol umm if u r good with a drill take out the spacer the one you have and find a drill bit that is like the same size.then find a like soda cap and trace the outline of the spacer use like a knive or dremel to cut around then use the drill to make the center whole lol.tell me if u still dont get it
|
#7
|
||||
|
||||
Quote:
__________________
IN NEED OF MONEY FOR MRC!!!! |
#8
|
|||
|
|||
do you have a motor case, that is junk? take off the rear case, with the two wires, take out the armeture, the place the case with the lil' hole facing up, the take a screw drver and hammer,pliers, and tap on it until it comes out, it looks like the bearings, it is only abit smaller, but it will work, try using hot glue to hold it in place, hope this helps, ill post a vid, if you want?
|
#9
|
||||
|
||||
lol go for it tell me how it turns out
|
#11
|
||||
|
||||
Quote:
__________________
IN NEED OF MONEY FOR MRC!!!! |
#12
|
||||
|
||||
no i just thought the case would be about the right thickness
__________________
IN NEED OF MONEY FOR MRC!!!! |
#15
|
|||
|
|||
here the link (http://www.youtube.com/watch?v=GkA_yEogoA0)
Last edited by madcat303; 07-08-2008 at 02:38 AM.. Reason: so i dont double post, sorry |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|