#1
|
||||
|
||||
sodering motor wires to the bord ?
I was just wonering if any one knew wat the purpose for sodering motor wires directly to the elcctronic bord
__________________
Quote:
|
#3
|
||||
|
||||
ok so its just for beter flow
thats good cuz evo motor wires are hard to get a hold of thanks for the help
__________________
Quote:
|
#4
|
|||
|
|||
Well, Xmodificationer pretty much said it.
When you solder the wires directly to the board, there is less resistance, since the bats or connectors(evo or gen1), there is "lag"(resistance.) This takes away power, and when you have a top-of-the-line car, with a hot motor and lithiums, you want to do that. It's not going to drastically make a change if your car is running the stock 4S setup, and a stock motor, don't bother. |
#5
|
||||
|
||||
but im thinking of donig it with a custom built motor if i ever get one built
shuld i do it then
__________________
Quote:
|
#8
|
|||
|
|||
Nah, it isn't worth it.
It does keep the tabs not touching, but it will help prevent shortages w/ the board cover on, if the wires are nice and secure to the pads. It will do that, no speed gain. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|