Converting RC18 Parts for ProPulse use - MY FINDINGS

[TheB1GDude]

This is a list of the RC18T Parts I purchased for my ProPulse along with some comments on the parts....

Part 1. 2x RC18T MIP Super Diff Differential Out Drives 18B 18MT

They seem to be to long for the gear box although this might just be because I can't get the MIP to lock correctly once I install the steel diff.

Part 2. 2x RC18T 18 Series Steel diff and input gear

I built up the diff with the ball bearings and washers then tried to fit it in the MIP but found that the stub on the one of the mip is bigger than the hole in the diff so it doesn't fit together properly.

The input gears do not mesh properly with the stock diff so can't be used.

Part 3. 1x RC18 series Delrin 56T spur gear

The stock spur gears have slots cut in them to hold the gear in place on the drive shaft, this doesn't.

Part 4. 2x Associated RC18T Front or Rear dogbones with springs

In a stock setup these dogbones are two short, the MIP's are slightly longer so they might work together but otherwise they aren't any use as they slip out.

These are my findings for these parts:

Part 1. 2x RC18T MIP Super Diff Differential Out Drives 18B 18MT

I have had absolutely no luck with getting the MIPs and steel diffs to fit together properly, so I'm giving up and cutting my losses and selling the MIPs.

Part 2. 2x RC18T 18 Series Steel diff and input gear

The steels diffs need a minor bit of dremel work to make the hole slightly bigger and then they fit perfectly with the stock diffs.

The steel input gear fits tightly onto the CF drive shaft and meshes with the steel diff nicely.

Part 3. 1x RC18 series Delrin 56T spur gear

The dog bones are a little short but appear to fit, if the pegs are sanded ever so slightly they should fit just right into the diffs at the moment its a really tight fit.

Part 4. 2x Associated RC18T Front or Rear dogbones with springs

The main gear as I've found out needs the RC18T drive shaft this is the only way you can get it to work and apparently its a fairly big mod.... I have the CF drive shaft installed so won't be doing this mod, at the moment the main gear is my weak spot....

In terms of what I'm selling, well the MIPs are gone so at the moment its just the main gear....