#1
|
|||
|
|||
slight issue with stack........
ok so i recieved my order today from atomicmods. got home from work (rs), and started on the gen1. after finally getting it all soldered and not shorting anywhere, i took a break and just went to go assemble it. now problem #1 is that now with it stacked (i have 3 on each total) it doesnt fit in the chassis......how do i solve this??? and also, when i took out the electronics, 2 yellow pieces came out....and i dont know where there supposed to go. and i found it quite odd that when i opened the gen1 up........the drive shaft was in there........but no front gear setup....odd
|
#2
|
||||
|
||||
what do the yellow pieces look like? a picture would help. You could cut a slot through the chassis to fit the stack in, but then the stack will be open to the elements. no front gear setup? did you have awd in it before? I dont understand what you mean by no front gear setup
__________________
Real Car: Honda S2000 A-tech XMT4 Tamiya TL-01 Tamiya TA-02 Traxxas Hawk 2 |
#3
|
||||
|
||||
hey ya pics would really be a help in this and like just sais fets need a slot cut out of the bottom of you chassi now wich is why im looking for a v2 board
__________________
LOOKING FOR 350Z MINT FRONT BUMPER!!!! Quote:
|
#6
|
||||
|
||||
Just cut your bottom part of the chassie for the fets to fit in it. The yellow parts are probally bushings, I think they belong to your driveshaft. It should look like a yellow round thing with a hole. The driveshaft is suppose to be there, all gen1s have em regardless of AWD or not. There should be a black stopper in the front if you dont have AWD.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|