#1
|
||||
|
||||
ok so i had fried my stock EVO fets and i bought some upgrade ones and i installed them. I put the 9-something one towards the front of the car and the 7-something one towards the engine. After i soldered it and put batteries, i turned the car on and my servo didnt line up....i tried to accelerate but nothing. I felt the FETs and they were hot and my batteries were really hot tooo?! what happened?
i know im double posting but i need this answered im so lost
__________________
Helpful Warnings: "CAUTION: Knife is very sharp. Keep out of children" ^ i got that from a box of kitchen knifes at IKEA aka DJ KraZe Last edited by DRFTKO; 03-21-2007 at 08:45 PM.. |
#3
|
||||
|
||||
i think they had to much load on them. that can be caused by somthing shorting it out like a hair leading from on fet leg to another or maybe it the solder was touching the next leg beside it and also shorted it out. make sure on the input side they are in single file(the little legs) and the output side can be all together. hope im clear enough. if not check out the AM tut on it
|
#4
|
||||
|
||||
allright i kinda get it now still need some more info
__________________
Helpful Warnings: "CAUTION: Knife is very sharp. Keep out of children" ^ i got that from a box of kitchen knifes at IKEA aka DJ KraZe |
#5
|
||||
|
||||
becareful when you remove fets....you can easily damage the contacts and then youll be F$$$'d
__________________
http://forum.psfights.com/index.php |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|