Gen1 Ford Mustang 1965 by "targetingxmod"

[targetingxmod]

Everything is in that photo. Use the Gen1 servo. It will be good, fine whatever!
Stock gen1 board is the weakest link and don't push that servo far away or any good in the short way it moves with it!

With a ASF miniz board it will move like any hobby grade servo.
Just open the servo and get the 3 wires pot out and the servo 2 wires motor out. Then wire those 5 wires to the miniz board like the million dollar pic's above shows! (the servo eletrics board leave it alone or remove...that job now is done by the miniz or losi micro board). We only need (inside the servo) the Pot and the motor. (3 wires + 2 wires)

All that stress into putting miniz boards or losi board into xmods it's those 5 wires of the servo on the boards that need to match the 5 wires of Xmods internals! After that they ROCK!