#1
|
|||
|
|||
standard electronics conversion
Hello!
I think there's a little higher-cost but less-painful solution to run ho motor on xmods:but it's just an idea: I thought about putting this receiver(the smalles on 27Mhz I've found) http://cgi.ebay.com/Mini-X-MX-RX-Rec...QQcmdZViewItem this esc(it's less than 1'x1'): http://cgi.ebay.com/MOPED-V16R-Plus-...QQcmdZViewItem and a micro servo,a 9gr type) I've ordered the receiver,I'll keep updated... I've gone for this conversion due to the waste of thime to put stacked fets on that eb with that tiny and low quality servo. Of course with this convesrion isn't possible to put the command logic,light,but you can safely run all the hottest motors on the market. Another conversion I'm going to try is to put a nanodragon2(mini inferno clone)electronic on xmods.It has rx/esc integrated(with esc capable of 400 clas motors)and a standard plug for the servo. |
#3
|
|||
|
|||
I've ordered the receiver from dinball just yesterday...
Thanking the UE custom( )I'll probably see that receiver in a month(hope....) My project consists in thisutting the mini-x receiver on nanodragon(that will have brushless motor)and then using the nano RX/ESC on an EVO to run hot motors. But first I need to get the receiver..so at the moment I'll not post any pics..I posted to check if anyone else could give me some advices or tips |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|