#1
|
||||
|
||||
BL micro-t Question
If I use this reciever in a BL Micr-t will I still be able to use the original controller?
http://www.atomicmods.com/Products/S...ms__12935.aspx
__________________
Last edited by bestdragon2001; 02-03-2008 at 05:00 PM.. |
#8
|
||||
|
||||
Well I think brushless woulbe too much for me so what if i get bearings, bb motor and liths what kind of speed would it have?
Also do they make any other better upgrades than them, like different motors and battery packs?
__________________
|
#10
|
|||
|
|||
MhHmmm.....
Well, re-winding the N20 motors, Ill leave that to RED, I cracked a stocker open, **** it was small Yeah, but these have been covered in other locations, getting a bit sick of repeating myself... Make your own battery pack. Wire a S2 LiPo pack... |
#12
|
|||
|
|||
The spider, you have to remove the stock fets...........
PH2T put a nelly on his, I bet it's the same for a V3... http://www.ausmicro.com/forum/showthread.php?t=14442 You're welcome. |
#14
|
|||
|
|||
Quote:
Lipo's and a Atomic BB motor will get you 30 mph in a micro-t. I would know, i have both. |
#20
|
|||
|
|||
ok, i was like what is civic saying lol. But yea There is really no point in going BL in a micro-t unless you have the money, or just want a fast RC car that runs for about 3 minutes. Seriously, save your money and just get Lipo, BB motor, Bearings, and maybe some gpm. But thats about it. Going BL wont make it a ton faster, and you will get alot shorter run times. Besides around 30-35mph is plenty fast for a car of this side. Argue with this and you will lose. I know my micro-t's.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|