#1
|
|||
|
|||
Knuckle not sliding
i encountered a problem with one of my front knuckles on my Gen1 after installing sealed bearings.
You know how the shaft just slides in? for one of them, i have to pretty much snap and click it in, and it doesn't roll nearly as freely as the other shaft does. Both knuckles now have the wide track bearings installed. I know its not the bearings because I've tried switching them over multiple times and it's always the same knuckle. I got frustrated and just ordered GPM silver knuckles from asiatees, but god knows how long that will take and I need a way to run it right now. Anyone have any suggestions? |
#2
|
||||
|
||||
check for any debris or messed up plastic in the knuckle
|
#5
|
|||
|
|||
i think it's a bit of messed up plastic and I haven't been able to really fix it.
Dontspamme, it is 2 widetrack bearings in the same knuckle. I've read that the front requires widetrack in both knuckles (cause i run RWD) while the rear only needs the outer knuckles. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|