#1
|
||||
|
||||
How to: servo swap
This is what i tried for my xmod so i would have the best of both worlds...a evo board, and a gen1 chassis. to do this i had to put a gen1 servo on a evo main board.
first we need to know what to solder to there are 3 solder pads to solder the servo wires to each with their own number, on an evo its (14), (15) and (16) should look like this now solder each of the gen1 servo wires to the board in this order on the board i actualy used longer wires and u should too, but make some sort of marker to remember what wires are which. mine looked like this if you dont put on new servo motor wires just solder the (blue to black) and (red to white). -/+ then solder the servo motor wires (red and blue) should look like this when done. Last edited by crunk rida; 04-19-2006 at 03:02 PM.. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|