|
|
|
#1
04-08-2007, 06:31 PM
|
||||
|
||||
burned fets?
ok heres my story, i was running my new titan (week old) with some mini offroading and suddenly it wouldnt move. now i could steer but i couldnt move. i checked my fets and i see a little yellow spots. (i cant get pics because they would be too blurry) did i burn my fets? this was my setup.
s2 motor, awd, lift kit and recharable batts. i know its not my motor because i tryed them all and the motor wouldnt run. did i burn my fets?
__________________
Co-Founder of Team evo drift good bye san jose grand prix, you'll be missed  Fighting in a forum is like being in the special olympics, Win or lose Your still retarded! 
|
|
#2
04-08-2007, 06:35 PM
|
||||
|
||||
|
sounds like it, do you smell burnt plastic?
|
|
#4
04-08-2007, 06:37 PM
|
||||
|
||||
|
i didnt smell it but i usally smell the s2 motor, or maybe that was plastic. i burned it yesterday and it was kinda windy so i didnt really notice
__________________
Co-Founder of Team evo drift good bye san jose grand prix, you'll be missed Fighting in a forum is like being in the special olympics, Win or lose Your still retarded!
|
|
#6
04-08-2007, 08:53 PM
|
||||
|
||||
|
Ehh, you might have, you might have not. The first thing I do is check all over to see if anything is binding. Next, I look inside the motor. Chances are, if your servo still gets power, your FETs aren't fried, and somethings screwed up in the motor (loose wind, wire breakage, brushes not touching, etc).
If these aren't the problems, chances are pretty high that you fried your FETs... Later, RedSXmodder
__________________
 Team Redmade Motors- Building Motors that rise above the rest! Rethink It All
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
