|
|
|
#1
04-12-2007, 04:24 PM
|
||||
|
||||
Surface mount component remover
hey i saw this video on the net and i just want to know if this would burn any fets and would it really work for the xmod electricity package? thx
heres the video: http://video.google.com/videoplay?do...27163860056532
__________________
 
|
|
#3
04-13-2007, 08:45 PM
|
||||
|
||||
|
Deffinatley. I don't think that its a bad idea, for something that doesn't have components on both sides that is...
With a gen1 (not sure about EVO) there are too many bottom components that would fry upon contact with the iron... Later, RedSXmodder
__________________
 Team Redmade Motors- Building Motors that rise above the rest! Rethink It All
|
|
#4
04-13-2007, 08:56 PM
|
||||
|
||||
|
Yes, but you can always just melt it with a soldering iron and take it out by hand without ruining the traces and bleeding solder all over the board...
Or just heat it and wack it against the table until it flies out.
__________________
After a thousand years of oppression,
Let the berserks rise again, Let the world hear these words once more: "Save us, oh lord, from the wrath of the Norsemen"
|
|
#5
04-13-2007, 10:34 PM
|
||||
|
||||
|
Quote:
oh btw, i need a new ep for a gen1 and an evo
__________________
BIANARY SOLO 00010001111010100010100010100101001011111011
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
