range problem...

[dylan1]

its weird i own a nissan titan and its starting not to go far away on its own.like ill drive about 8ft away and then the lights will shut off and i have to go closer to it for it to work again.any ideas?

[Lowrideit]

You problay Fried your range...

[spartanman]

that is weird mine does not do that are you in a house. doing it

[snowboi1289]

did the car antenna touch the motor?? that would fry your range..

[2wdpancar]

If you have touched your antenna on the TX to the antenna on the truck, you fried the range inductors.
I would buy a replacement board, I'm still trying to figure out what value the EVO resistors are, I fired 3 cars in 1 week, then sold 6 cars with fried inductors...

[REDisFASTER]

The search feature on the top of this forum works wonders

http://www.xmodsource.com/forum/showthread.php?t=5643
http://www.xmodsource.com/forum/showthread.php?t=6401

Try it before creating a new thread next time.

[dylan1]

well i am in the house while running it.should i try outside?and i dont think i touched the antenna to the other antenna but if i didnt i dont know about it

[ling427ttvette]

Edit: I seemed to have mis-understood a post and worded this one wrong.

Anyways, my Titan chassis seems to have an odd problem.

When the truck gets about 15 ft or so away, it sputters. It goes, quits, goes, quits, and it does it rapidly. And then as it gets a little closer, it has no problems.

Could the problem lie in the crystals maybe? The one that's in it went in a little rough, and when I pulled it out of another one of my cars, it bent a prong slightly but I bent it back without breaking it.

[2wdpancar]

Originally Posted by ling427ttvette

This might explain why my Titan chassis doesn't seem to have as far of a range.

I don't run it with a body and with as high as it sits it rolls over easily. I bet the antenna touched the motor..

The board has to be replaced to fix that? Seems a bit complicated, but it might be worth taking a stab at when I am feeling like a challenge.

Yes, you need to replace the whole board.
Just unsolder the wires, mark where they go, and solder in the new one.

[ling427ttvette]

Originally Posted by blt456

Yes, you need to replace the whole board.
Just unsolder the wires, mark where they go, and solder in the new one.

Ah, maybe I didn't mis-understand it then?

I did edit my post though, any thought as to the trucks problems? Think it could still be the board?

[2wdpancar]

I bend the prongs all the time!
Nah, but I bet the inductors are damaged= affected range= need of a new board.

[ling427ttvette]

Sounds like alot of fun..

Where can I get a new board for a good price? Or would I be better off finding an EVO chassis for parts and using the board out of it?

[2wdpancar]

Go to XI and get one...cheapest place I know of.......

[ubermod]

or here
http://cgi.ebay.co.uk/ws/eBayISAPI.d...MESE:IT&ih=012

[xmodscarbon's_lost]

you could go here to increase it..... Increase your Xmods range