custom neon underglow

himynamebebrian · #1 02-16-2009, 01:00 PM

is there a way to make a cord or buy a cord to make a custom neon underglow? ive seen the like 40$ ones but i don't have that much money. if you have done it please post pictures

thanks thanks you.

noturday · #2 02-16-2009, 02:33 PM

SEARCH BUTTON AMIGO!
http://www.xmodsource.com/forum/showthread.php?t=11258

himynamebebrian · #3 02-16-2009, 02:43 PM

sorry, i wasn't clear. i have a gen1 and i DO NOT want to buy the kit, is there anyway to make a TUBE like light for a SOFT underglow.

Action B · #4 02-16-2009, 02:48 PM

Quote:

Originally Posted by himynamebebrian

sorry, i wasn't clear. i have a gen1 and i DO NOT want to buy the kit, is there anyway to make a TUBE like light for a SOFT underglow.

There is, my friend has done this. Let me ask him how its done and get back to you in a bit.

himynamebebrian · #5 02-16-2009, 02:55 PM

ok, thank you.

rsx racer · #6 02-16-2009, 04:34 PM

Take 4 LEDs, and two straws... See where I'm going with this? Mount under your liions and call it a day.

civicblack10 · #7 02-16-2009, 04:47 PM

Yeah ive done one before the way rsx racer mentioned it. Stick a LED in each end of a straw and stick it under the battery mounts or under the front & rear bumper or both. Then cut a small slat or opening on the bottom of the straw, a bigger opening will let more light through.

himynamebebrian · #8 02-16-2009, 04:50 PM

ok, does it make alot brighter by the end where the LEDs are placed? does anyone have pictures of this?

rsx racer · #9 02-16-2009, 05:14 PM

It doesn't matter where its brighter, the lights are under the car. All you will see is a glow from all sides.

himynamebebrian · #10 02-16-2009, 05:26 PM

it does, because i don't want the 2 ends to be 2x brighter than the middle, that IS a point to me asking that.

bondo · #11 02-16-2009, 06:49 PM

instead of using clear straws go to ace hardware and get clear 1/4"OD fuel hose(about a buck a foot) and mount the LED's above and infront the wheel wells then run the middle of the hose near the bottom of the side skirt.
the tube will carry the light and with the LED's mounted higher then the tube the light emitted to the ground will even out.
if the light is still greater at the ends then use a bit of scotch tape near the LED's.
less light will pass through more layers.

himynamebebrian · #12 02-16-2009, 06:53 PM

Thanks Thats Alot Better Idea! :d:d

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)