how to make custom deep-dish rims

[noturday]

ok, i was just informed that this got deleted in the hack a while back so here it is again, here is how i make deep dish rims out of rims i already have

Things you will need:
1. set of rims to be modified
2. dremmel with cutting wheel
3. hobby knife
4. light grit sand paper
5. super glue
6. patience

start by finding a set of rims you want to make into deep dish rims, i chose the scion tc stock rims (only 2 will need to be modified)


look for the place that you need to cut it so that it will have a nice depth but still be functional (here it is right in between the ridge and the back of the spokes)


using your dremmel, cut the wheel at the spot previously located and separate the 2 portions (use the ridge to help guide you around the rim)


use a hobby knife to remove any excess plastic left by the cutting wheel


test fit the two pieces together how they will be joined, and use sand paper to even it out to prevent from creating an out of round wheel


once the two pieces are ready, carefully glue them together, making sure they are centered with each other


after you have modified two of the rims this way, you can add some tires and try them out


if you want to take it an extra step you can always give the rims a new coat of paint

[supraboi97]

Thanks again for putting this back up it will help alot

[Stampedekid]

Thanks again for posting this up! I don't have a dremel, but my dad does.

[kungpow420]

I never saw this tut before it is a good one and that 350z looks way cool although I think the scion bk rims looked better on it.

[snowboi1289]

i did this,its extremly hard to do with a razer blade..thats what i did..this will help alot of other ppls..