#2
|
||||
|
||||
You are going to have to open the servo and cut out the board, (now it is a 5 wire servo) and the power wires should be the same(red and black), the pot i have no idea. just experiment but it is a 2 wire pot... the power/motor is easy, the pot is hard, i have heard of the ruining a z board with the pot wires wrong.
Don't try it my way until some further info. I have done this to a micro t esc(jr sport sm22)and xmod evo board(hs-55)
__________________
Track car v2.0 fieldfairy2's mini late model Operation black widow H-Crawler |
#3
|
||||
|
||||
Just guess and check for the pot, and if you have a Futaba, check that your servo is not made in China. I was talking to the owner of PN Racing, he had a batch of China-made Futabas that burnt up several of his Mini-Z boards. Taiwanese Futabas are good. If it's a Hitec, just guess and check because it won't do the board or the servo any harm if you get it wrong.
__________________
Greyscale Racing |
#4
|
||||
|
||||
Quote:
inside it has a green and a white wire going from the board to the motor. and also a black one grounded to the side of the motor. the brown, orange and red wires from the plug go to the board. What exactly am I contecting where. from the MR02 board to the servo. |
#5
|
||||
|
||||
the ground wire you cut off, it doesn't matter. white is probably positive and green negative for the motor/power, lighter colored wires are usually positive, the pot you just need to experiement.
__________________
Track car v2.0 fieldfairy2's mini late model Operation black widow H-Crawler |
#6
|
||||
|
||||
Quote:
Thanks guys I think i got it. It works but has a little gitter. |
#8
|
||||
|
||||
I have one, but its a little big, This one is smaller then the HS-55. But wheres the tutorial, I tried to find it.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|