Blade.'s attempt at a 1:1....Project?

[Bananabrain]

That is looking really cool, can't wait to see it mobile.

[Blade.]

Update.

Been up drinking, and tinkering. Lastnight that is, then I found it today in the morning, after forgetting what I did lastnight. I realize that I cut up the interior and did some mock up items for the driveline issue, but now I need to fix the rear suspension cause' I think it may be out of wack right now cause of this.

Anyhow, this is the final completion of the rear end, with stiffer items that are not styrene/sheet plastic, it's a 7UP can! Go figure what you have when your done drinking.



The Engine will be over top of the Bevel Gear, it should rotate like a normal xmod... I'm hoping atleast.



Connection between the rear differential and rear bevel gear.(Hole will be fixed when body work starts haha.)



She's got plently of clearance, she's just up on a 1/2inch lip on the front so the rear looks like it's close to dragging.



And that is the bottom, the middle part came out perfect, and that is what was needed greatly to make the drive-shaft a semi-floating driveshaft.

She's getting closer, I'm hoping the steering linkage will clear where the "engine"(motor) will be sitting... I really hope...

Anyhow,
C&C please.

Blade.