#1
|
|||
|
|||
whats wrong?
I got an F150 a while ago with stacked fets, lithium-ion's, and a stage 2 motor. I drove it around for a bit and then it started smoking and literally burst into flames! So I bought another electronics "package" swapped it out and now the steering works but the motor wont go... it went for about 1 sec after playing with it for a minute... then I saw smoke again.... Is my motor fried? This time I ran it on the stock batteries...
This sucks cause I just bought some more gpm for it.... Maybe I should cut my losses and just buy a new one? Well I figured out that my motor was fried, which may have caused my FETS to burst into flames? I put another motor on that I had kicking around and it is gutless!!!!! so a new motor is in the cards pretty soon
__________________
I fried my f150 board anybody got one? Last edited by chrisk; 04-30-2007 at 05:43 PM.. |
#2
|
|||
|
|||
You have binding somewhere the board is burning up because the motor is bound. Check your gear mesh. That happened with my first car. I hope you just went out and bought another car as opposed to paying 25 bucks for just the board.
|
#3
|
|||
|
|||
what do you mean by binding? like something is making it run slower? or rubbing against another part of the drive train?
__________________
I fried my f150 board anybody got one? |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|