need help!!!!

[haze]

i know that the wires connected to the batteries disconnected.....but i dont know how to take the battery tray off so i can get to the wires....oh yea its a evolution mustang

[mini-z drift]

okay take a knife or somethin thats thin and a bit wide. right were the battery clip clips on to the tray, right above there should be a groove. put a knife or thin wide thingamabob and push down . do that to each side until it comes off.

[Darkmagik]

Originally Posted by mini-z drift

okay take a knife or somethin thats thin and a bit wide. right were the battery clip clips on to the tray, right above there should be a groove. put a knife or thin wide thingamabob and push down . do that to each side until it comes off.

i have no idea what you tried to say but ok

[4banger]

"thingamabob and push down"

[librarianliam]

theres 4 tabs that hold it on to the bottom after you take out the screws that is what the thingamabob is...

[bondo]

remove the board cover.
remove the board.
now you should see the four tabs mentioned above.
using 2 flathead screw drivers, place one in the slot for a tab and pry away from the u-channel(where the switch rests) with one and pry down between the tray and board housing with the other.
repeat for all four tabs and your done.

cheers,
bondo