GPM motor cradle not meshing right?

[Bananabrain]

Ok, well I ordered a GPM motor cradle for the Evo, installed it and put in the 9 tooth gearing and that meshes properly. But were the main gear mesh's with the Diff, it is not meshing right it is skipping teeth and I can't move the car when it is sitting on the ground.

Any ideas on how too fix it? Or do I need to order a GPM rear gearbox cover?

Also the screws are all in nice and snug and it runs while being held in the air, but when its on the ground it grinds.

[lol]

Are you still using bushings? Bushings are very loose and allow it to move all over the place like a rag doll.

[Bananabrain]

Originally Posted by lol

Are you still using bushings? Bushings are very loose and allow it to move all over the place like a rag doll.

Well that could be it. Since I don't have bearings yet. Also I fried my 2x2 stacked fets so im not sure how that happened yet. But for now I switched back to the stock motor cradle.

[Blackdragon]

Make sure your main gear is not worn out and that all bearings/bushings are seated correctly. I never had that problem with mine but I always put in metal bearings when I upgrade the motor cradle.