|
|
|
#2
02-21-2009, 07:53 PM
|
||||
|
||||
Yes you can mix and match the bodykit pieces...
No with the truck slammed rims and car tires the front wheels still rub on turning and the rear wheels don't actually move unless you sand down the rear arches.... {EDIT} Its a bad photo but heres my Mustang shell on a stock Barricade chassis with slammed rims and car tires: 
__________________
Duct Tape is like the force:- it has a light side and a dark side and it binds the universe together.....
|
|
#3
02-21-2009, 08:54 PM
|
||||
|
||||
|
the hood, roof and other bk pieces will all fit with some minor mods...the same goes for saleen bk pieces on the mustang
__________________
 Team X.I.
|
|
#4
12-10-2009, 03:15 PM
|
|||
|
|||
|
To make the truck wheels fit the best, stretch car tires over the wheels, and the upper slip screw in the suspension should be swapped for the slip screws in the stearing linkage because there longer... This will lift the car higher out of the wheel wells to clear the bad to the bone rims for you!
 Hope this helps!
|
|
#5
12-11-2009, 09:05 AM
|
||||
|
||||
|
i actually didnt have rubbing issues on the 05 mustang or the barricade and i lowered them and put diufferent front clips on them and the slammed rims didnt rub.
__________________
 bad spammers  !!!Quote:
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
