|
|
|
#1
10-07-2009, 05:32 PM
|
||||
|
||||
board problem
ok im not sure where this would go. but i recently wuz resoldering wires on my Gen 1. ( some of them broke ) then when i went to turn it all on again. power does go to the servo but duznt jitter anymore. but no power goes to the motor. so it wont even run. i used fresh batteries. checked the wires multipul times. and everything seems to be right. nothing seems to be fried its kinda dirty but didnt effect it before. anyone have any ideas of wut i could check or try and fix??
|
|
#3
10-07-2009, 06:10 PM
|
||||
|
||||
it wuz working before. just had a few loose wires on the batt packs
|
|
#4
10-07-2009, 06:57 PM
|
||||
|
||||
|
Any possible chance you can post detailed pictures of your recently soldered connections? Maybe a pair of fresh eyes will be able to spot something you're missing.
Cheers, Kyle.
__________________
XMS Rules & Guidelines | B/S/T Rules | How To Post Pictures Greyscale Racing Member
 The Collection: Mitsubishi Pajero | AE RC18MT TLMicroCrawler | Xmod ShowRoom | 'Yota XTruck "The fun begins when the pavement ends."
|
|
#5
10-07-2009, 07:22 PM
|
||||
|
||||
|
uhh yeah sure i could try. ther kinda amature though haha first time doin it. but it worked before then i dunno wut happened to it. ill post them in an edit if i can
EDIT: ok i would show you guys pics. but i have no batteries charged but i think i know why it duznt work. the whole frequency board came off (part you stick chip in) its hangin on by glue where the wires were connected. anyone know a link to show me where the wires go? maybe i can solder them back on. if not im just gunna buy a new electronics kit from xmodsinternational and maybe have someone install tight turns or something Last edited by NissanDrift56; 10-07-2009 at 07:36 PM..
|
 |
| Currently Active Users Viewing This Thread: 2 (0 members and 2 guests) | |
|
|
Linear Mode
