|
|
|
|
|
#2
04-22-2010, 01:53 PM
|
||||
|
||||
Quote:
Model No. 11AM33 Product Name Anima II Modified Motor Product Detail The Anima II has been designed with the open class racer in mind. PN highly recommends using an external turbo or a 2x3 or more FET stack to run this motor. A quick look at the stats and you’ll see why. If top end and torque is what you crave for your 2WD look no further, this is the motor for you. Designed for: MR01, MR015, MR02, and F1 An external turbo or a 2x3 FET stack is required. Stats: - 25% faster then the Anima - 33 turn balanced armature - High temperature wire - New endbell design for increased cooling - High performance carbon brushes - Ball Bearing can, front and rear - Gold Neo Magnets Performance – no load Speed = 42,075 RPM Current = 1.1 AMP At Stall Extrapolation: Torque = 346 g.cm Current = 37 AMP (MUST BE A TYPO, PROBABLY 3.7AMP - Action B) Hope this helps!
__________________
XMS Approved Service Provider I install FETs and do repairs on Xmods and Mini-Zs including the new 2.4Ghz ASF boards and MR-03s. Last edited by Action B; 04-22-2010 at 01:56 PM.. 
|
|
#4
04-22-2010, 04:32 PM
|
||||
|
||||
|
A quick tip:whenever looking at motors. just keep in mind anything below 45T WILL require an FET stack.
its very rare that something else would matter besides the amp drawn. also, keep in mind if you use the wrong gearing setup(depends motor to motor)you'll blow your FETs. Later, T.I.M
__________________
"Where There's Will, There's A Way" "Many Of Lifes Failures Are Those People Who Did Not Realize How Close They Were To Success When They Gave Up" 
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Hybrid Mode
