|
#1
|
||||
|
||||
T2 vs Z2 vs chili
which 1 would win in a circuit race, drag, drift?
just wonderin which 1 cause i got all three
__________________
"Where There's Will, There's A Way" "Many Of Lifes Failures Are Those People Who Did Not Realize How Close They Were To Success When They Gave Up" |
#6
|
|||
|
|||
...stacking FET's after installing a V2.2 doesnt do anything, because the borad bypasses the FET's. hence thats how it works...so sound like you have no idea....
|
#7
|
||||
|
||||
what about the chances of frying the motor? cause i have a v2.2 as well
__________________
"Where There's Will, There's A Way" "Many Of Lifes Failures Are Those People Who Did Not Realize How Close They Were To Success When They Gave Up" |
#8
|
||||
|
||||
I didn't think the V2.2 bypassed the FET's I thought it was only the Nelly and Spyder upgrades that actually bypassed them but the V2.2 could be used in conjunction with stacked FET's.
__________________
Duct Tape is like the force:- it has a light side and a dark side and it binds the universe together.....
|
#10
|
||||
|
||||
i dont get it.....
__________________
"Where There's Will, There's A Way" "Many Of Lifes Failures Are Those People Who Did Not Realize How Close They Were To Success When They Gave Up" |
#11
|
||||
|
||||
its very complicated but you shoudl go with the chilli and the v2.3
__________________
LOOKING FOR 350Z MINT FRONT BUMPER!!!! Quote:
|
#12
|
||||
|
||||
Quote:
BTW i will use chili but WITH chili sould i use 2X6 stack, v2.2, nelly, v3 spider?
__________________
"Where There's Will, There's A Way" "Many Of Lifes Failures Are Those People Who Did Not Realize How Close They Were To Success When They Gave Up" |
#13
|
||||
|
||||
if you go with the chilli i am going to say use the stacked spider if you can get one
__________________
LOOKING FOR 350Z MINT FRONT BUMPER!!!! Quote:
|
#15
|
||||
|
||||
Here's an idea:
Take the T2 arm out of the can, and swap it for the chili's arm. Then, put the T2 arm in the Chili can. The T2 has a lower wind count than the chili, so you'll gain RPM. Later, RedSXmodder |
#16
|
||||
|
||||
I knew you would show up with the best answer
|
#17
|
|||
|
|||
Genius Red.
|
#18
|
||||
|
||||
Pure genious.
__________________
Brushless RC18T, Brushless Micro DT, Midwest AeroStar .20, SCX10 Honcho, Duratrax 1/5 Firehammer MT, Traxxas Nitro 4Tec 3.3 |
#19
|
|||
|
|||
No...
Motors..lol.. Quote:
Quote:
Yes. The T2 arm in the M1 endbell BB can would be one of the fastest machine-wound motors available. Quote:
Red, is the M1 better than the quick-release Atomic endbell? What's the difference, I know the M1 uses springs to push the brushes onto the comm, but is that it besides the cooling? Last edited by 2wdpancar; 01-07-2008 at 01:11 AM.. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|