![]() |
#1
|
|||
|
|||
![]() Hey guys, I was browsing through Towerhobbies and I saw these motors. I want these for a drag motor in my Gen1 camaro. Heres the 180: http://www3.towerhobbies.com/cgi-bin...?&I=LXJSH0&P=7
And then there is a Heli-Max motor: http://www3.towerhobbies.com/cgi-bin...&I=LXPCP2&P=ML there is a front and a rear Heli-max but I don't think it will matter. Will these motors run off or stock fets? |
#2
|
|||
|
|||
![]() There's no way to determine that, no winds mentioned, cans, etc...
It looks like garbage, but XmodsNut seems to praise that HeliMax motor a lot...... Still looks bad.. ![]() Just handwind a s1, get a few off AM, and do what you do. Last edited by 2wdpancar; 03-05-2008 at 10:49 PM.. |
#3
|
||||
|
||||
![]() You'd have to check it with a multi-meter off a constant voltage of 4.8V to see if it would blow the stock FETs or not. The other way is just test it on a stock board and hope for the best.
![]() I'm assuming the front motor goes to the main rotor and the rear motor goes to the tail rotor. I could be mistaken, however, as I've never really delt with a Heli-Max. If that's the case, the front motor would be more powerful because it deals with the most important rotor.
__________________
XMS Rules & Guidelines | B/S/T Rules | How To Post Pictures Greyscale Racing Member
The Collection: Mitsubishi Pajero | AE RC18MT TLMicroCrawler | Xmod ShowRoom | 'Yota XTruck "The fun begins when the pavement ends." |
#5
|
|||
|
|||
![]() Quote:
![]() |
#6
|
|||
|
|||
![]() Quote:
![]() Lol, it sucks because: -The can, brushes, and mags are of some of the lowest quality. ![]() |
#7
|
|||
|
|||
![]() No crap I know they are
![]() Last edited by xmodificationer; 03-06-2008 at 09:59 PM.. |
#8
|
|||
|
|||
![]() Quote:
![]() ![]() M1 endbell is more expensive than an Atomic quick-release. ![]() |
#11
|
|||
|
|||
![]() Quote:
t work. If it works, I give you props lol ![]() |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|