do you have a 3 of 4 channel tx/rx?
You could essentially run 2 speed controls with a receiver that can power channel 1(usually throttle) and channel 3(aux) in unison.
Unfortunately at this scale two escs are unlikely to send the info to the different motors at the same rate...even if you're off by a millisecond you will trouble the meshing of the driveline.
I did a Mamba 6800KV setup a long time ago on a Gen1 mounting in a team associated rc18t kind of way and once I got it running it pretty much vibrated apart on each speed run attempt.
If it were me today I don't think I'd use the Losi system due to the small sized BL motor and it's use of the 1.5mm prop shaft. There are 130 sized motors from PNRacing, Atomic and Kyosho meant for mini-z brushless systems that can also run on Castle Creations esc's...even though you probably should only run 2 cell li-po on those motors you'd get going pretty fast with the right gearing.
|