An Update, and I have some questions for anyone using the EZ-Run or who is a brushless, 2.4ghz EXPERT.
Got all the electronics in.
Painted the wheels RED.. I have new Black wheels on the way.
Finished the body, Murdered in out with all Black, since Im a big fan of that look and mostly because Im to much of an amatuer painter to anything more eleborate without ruining it. LOL
And here she is... HOT.
Okay, here is my question... Im having some problems with my EZ-Run.. I have it all set up, the 2.4ghz RX is bound to the TX, and I initiated (bound) the EZ-Run to the TX.. It runs great for about 20 seconds, then it cuts off, and when I pull the trigger it just gets a quick burst and won't run, so once that happens it only goes like 3 inches forward then stops everytime I pull the throttle. Sometimes if I let it sit for a minute, then it will run again then after 20 seconds it does the same thing. I re-programmed it, turning off any shut offs like for over heat or low battery.. and still the same thing.. Any ideas.. The instructions says either throttle signal is lost, check wires.. or the ESC went into low voltage shut off (Which I disabled) and I know the voltage is good.. Could it be a faulty capacitor sucking the battery power.. ????????? I want to play with my 18R.. HELP !!!!!!!!!