got bored tonight. so I put the intake mani and heads together and used some crap from around the basement to do a little mockup to plan out my intake.
then I put the cam pulleys on the heads, and used that as a reference for where the blower pulley should be.
left to right.
1. this piece is laying across the tops of the heads, referencing where the bottom of the blower will be.
2. representing the timing belt location
3. representing the alt, PS, and blower belt location
the Air-Water intercooler I'm planning on using is 13.5" long. I was able to get just over this between the output on the blower and the throttle body. my high-pressure intake track is just going to be 2 90 degree couplers and the IC. pretty sweet!