View Single Post
  #1  
Old 11-25-2006, 11:34 PM
Luk3's Avatar
Luk3 Luk3 is offline
Banned
 
Join Date: Oct 2006
Location: my computer
Posts: 489
Trader Rating: (1)
Send a message via AIM to Luk3 Send a message via MSN to Luk3 Send a message via Yahoo to Luk3
Default Masking Double Sides

I know you all like to paint custom graphics,but hey heres a way to help.

Supplies needed: masking tape, hobby knife, a piece of glass, and a light source.

It's one thing to be able to make a mask for one side of a subject. It's another to have both sides the same. While you can cut a template out of paper I like to use tape for the actual mask and for the template.

First take some tape. If you don't have wide enough tape you can stick some strips together to make it the required width. Here I am using Tamiya masking tape. It really is as good as every one says it is and I can't recommend it enough.

Stick the tape on your subject and simply draw your graphic or pattern. You will have to excuse me as I finished this car and thought afterward I should share this trick with others.



Next, remove the tape from the subject and place it on a piece of glass. Glass is great because it's a perfectly flat surface and makes cutting the tape really easy. The knife just glides along. We'll have another use for it later on as well.



Once cut you have the option of using the negative or the positive of the pattern, what ever your design requires.



Remove the one side you don't require and flip the glass over. Cover your pattern with more tape as shown.



You can do this a few different ways but what you need to do is shine a light source through the glass so it reveals your pattern on the back side.



Trace this pattern and cut with your knife. You will now have a perfectly matched LH and RH mask. Depending on how square the glass is to the light your pattern might be off to one side or the other. This happened to me. I removed the top mask and placed it directly over the bottom mask just to show you that they do come out the same.



All you need to do now is position the mask on the car the same for one side as the other. Look for body lines, door handle locations anything that will help getting the masks positioned the same from one side to the other. On this particular car I needed a roof mask. I put the sides on first then made a roof mask to tie everything together.

Look how close the red dots are from one side to the other. You can't get much closer than this!


Thanks To Brent From BMC For Making This