Well, this DT is suppose to be the brushless one, but I don't have a reciever yet, and wanted to bring it with me on Xmas Vaca.. So I did a quick rebuild. I made a temporary Lith pack using 2 AAA liths.
The 2 liths, on top the chassis, fit nice... No destruction to the chassis.
Did have to make a couple cut outs in the body though.
I made a cool little Antenna holder on the body, since I hate the little antenna wire flapping everywhere.
Here is what I did, I soldered a male pin plug to the end of the Antenna, and a little shrink tude.
Then I glued a small female pin plug to the rear of the body. The pin plug just plugs into it and holds it there.
Resluts... looks cool to me... runs fast for now, until I get my lipos, and the reciever to finish the brushless install. I also tied the cotter pins to the bumbers so I don't lose them.