[TheB1GDude]

Hi all,

Been a crazy busy year with work so all RC stuff has been basically minimal... I still try to get out with the AX10 whenever possible so here are a few crawling shots:









The one thing I noticed that really became annoying was whenever I went over the smallest little rock I would pop either the front or rear drive shaft thus loosing drive to those wheels. So got myself a set of MIP drive shafts and just finished up installing them:



Worst part was the hex nuts on the stock cups had been stripped so I ended up drilling out the cups so I could get the MIPs installed but anyways they seem much tougher and will hopefully sort out my problems.