View Single Post
  #1  
Old 04-19-2006, 02:59 PM
crunk rida's Avatar
crunk rida crunk rida is offline
Banned
 
Join Date: Aug 2005
Location: North-west FL.
Posts: 800
Trader Rating: (0)
Post How to: servo swap

This is what i tried for my xmod so i would have the best of both worlds...a evo board, and a gen1 chassis. to do this i had to put a gen1 servo on a evo main board.

first we need to know what to solder to
there are 3 solder pads to solder the servo wires to each with their own number, on an evo its (14), (15) and (16) should look like this

now solder each of the gen1 servo wires to the board in this order

on the board

i actualy used longer wires and u should too, but make some sort of marker to remember what wires are which. mine looked like this

if you dont put on new servo motor wires just solder the (blue to black) and (red to white). -/+
then solder the servo motor wires (red and blue) should look like this when done.

Last edited by crunk rida; 04-19-2006 at 03:02 PM..