View Single Post
  #50  
Old 05-04-2009, 11:40 PM
Numbchux's Avatar
Numbchux Numbchux is offline
The Daywalker
 
Join Date: Feb 2006
Location: Duluth, MN
Posts: 1,509
Trader Rating: (1)
Send a message via AIM to Numbchux Send a message via MSN to Numbchux Send a message via Yahoo to Numbchux
Default

yesterday I ran a couple errands. and came home with this:


a cylinder honing tool....with it, I did this:


mmmmm.....fresh hone.


some parts

NPR piston rings
ACL main and rod bearings
PCI timing kit
GMB new water pump
head bolts
and an OEM engine gasket set



today some progress. bolted the case halves together:


rear main seal in


oil and water pumps installed. pistons, as well as coolant bridge, and wrist-pin access plugs.








once again, not much to do until more parts come. this time waiting on the ported/polished heads with reground cams to arrive from Delta.
__________________
-Chux

"Where are we going, and why are we in a handbasket?"
Subaru --- All We'll Drive
Member: NSW, USC, MNS, C4C. Founder/Owner: NCC
Reply With Quote