More videos of the evo board working on the gen1 chassis!
http://www.youtube.com/watch?v=rYVLr82Xxdc
http://www.youtube.com/watch?v=_qh6KYeKUi8
My stress for the GEN1, is now on the working progress...
-Hammer it
:shock: I used a old motor arm and puted the metal pinion that i get out from the 8 gear motor with a hammer.
-Then i GET out "again" the pinion with a pinion puller...
-And puted the pinion on a new racing motor .... by hand, it was very hard, but doable...
-In the almost end... i used a vice.
-With some tape and metal ring/shims "whatever" for the shaft get out a little....
-And it's done.... I am so happy now! :halo:
-The tape used, and the final job done!
-And breaking the new motor in!
Need time to put this on the GEN1. I am passing from 26.000rpm motor on 4.8v which should be more on 6.6v... to 41.000rpm on 4,8v... which indeed with 6.6v give .... more rpm's :devil: