View Single Post
Old 04-05-2009, 03:43 PM
XMDrifter's Avatar
XMDrifter XMDrifter is offline
drifter and engineer
Join Date: Jul 2006
Location: St Louis
Posts: 2,179
Trader Rating: (5)
Send a message via AIM to XMDrifter

you don't need to use the stock can. all armatures are (except maybe a few) standardized in size.
you can take the stock arm and rewind it. don't need to buy a whole new motor. after you rewind it, it'll fit into virtually any motor can. (you might have to take some of the little thin plastic washers off the ends)
Reply With Quote