Quote:
Originally Posted by RedSXmodder
I think that one of the FETs controls steering and one the motor. You probably fried the motor FET, the same thing happened with my mustang...
Later,
RedSXmodder
|
there are four fets total. the 2 on top control the motor and the two on the bottom control the servo motor.
you didnt blow a fet. you would know if you did.
check all of your batts and make sure the crystals are the right way. (car for car/tx for tx)
if the controller doesnt work then open the board and check all of the wire connections and look at all of the solder points with a magnifying glass.
look for cracks/holes in the connections.
check the wires for freying and make sure that all of the wire is in the solder connection.