So as you may have seen in my modification thread, I was gathering Ideas for my Rally Car.
So far this is my current status:
Body-STi
Chassis-Street Chassis.
Visuals:
C.F hood (from Body Kit)
Disc Brakes
Suspension and Steering
Grey Shocks
Medium Springs
Custom 7mm suspension increase. (Thanks Dreaming is drifting)
Raising Arms
4.5 Degree Tie Rod
Drive-Train
R.S AWD Drive Shaft and corresponding gears
Ball Bearing front differential
Aluminum Dog-bones W/ Axels x4
Sealed Bearings
Motor/Gearing:
AWD lll Motor
12-23 Gear Ratio
Electronix:
V2 Motor turbo from X.I
Motor wires directly soldered to ports on the board
R.S Rechargeable AAA's
Wheels and Tires:
STi Rims W/ Custom Rally Tires (thanks 4 the Idea)
Zone Z1 Rims With Custom Studs
So Thats What I've Got so far. I'd Say it's about 75% done.
I drove it on the ice last night. My custom studded wheels are amazing!
I'll explain the studs if I'm asked to. BUT what I really need Ideas for is A lightweight chassis protection system. I can't seem to find any thin lexan. What should I do?
P.S.
Comments on the Parts list Is welcomed.