Quote:
Originally Posted by xmodzracer
lol now plug it in...
|
lol, working on that. start soldering once i finish this beer. dont want it to get warm
Quote:
Originally Posted by dontspamme
Too bad the wires are on the wrong sides and he's missing the clip.
Other then that, you might want some GPM for that beast. You'll be snapping those front/rear cups 24/7 ! Looking real nice, can't wait till the finish product is revealed!
|
yeah, ill be looking into gpm before long and its getting deans.
Quote:
Originally Posted by SkylineLvr
I believe those motors you have to flip the brushes 180 deg, or just wire them up like he has them
|
no, the flipping of the brushes is on the m1 endbells, i just have to either switch the wires, or when i put the deans on solder the black wire to match up with the red wire, and vice cersa
Quote:
Originally Posted by texan_idiot25
Gen1! yes!
It's been a long time since I've seen a 180 Gen1 lol..
|
lol, last one i remmber off the top of my head was goodfellaz quick and dirty drifter if i remember right.