View Single Post
  #6  
Old 06-26-2008, 03:50 PM
crawlin duckies's Avatar
crawlin duckies crawlin duckies is offline
Advance member
 
Join Date: Jun 2008
Location: utah home of the mo mo assault vehicles
Posts: 120
Trader Rating: (0)
Send a message via AIM to crawlin duckies
Default

Quote:
Originally Posted by noturday View Post
sounds like the pinion gear on the motor is loose. i had this same problem with my radline (i also put a helicopter 180 motor in it)

heres how i fixed it
1. take the motor out, but leave it to where you can still run it.
2. take the pinion gear off the motor
3. grab some low grit sandpaper (400-800ish)
4. wrap the sandpaper around the end of the pinion and run the motor. (this will make rough edges on the pinion for the gear to grab a hold of)
5. when putting the pinion back on the motor put a couple drops of superglue into the pinion gear then slide it on and let it dry for a bit.
6. after the pinion gear is glued to the pinion you should be able to re-install the motor and try it again.

hope this works for you, it fixed my radline
whoo hoo!!!!!! it worked!!!! thank you for the help she runs like a charm
__________________
IM A DRINKER!!! NOT A FIGHTER!!!
Reply With Quote