Stage 2 motor problem???
OK i was driving my car and like 2 minutes later the motor just stoped. I took it apart put it back together ran for a second then nothing. The sterring still works but the motor doesnt. I thought it was the board so i wired my stage 1 motor and it ran perfect. So i hooked the stage 2 back up and nothing but if i spin the armature a few times and hit the gas it would go?? then nothing.
whats wrong? also I only used this motor 4 times. |
Check your batteries and see if you have the right spacer in the motor to go with the pinion. Also see if anything is binding.
|
whats the spacer??
|
When your changing the motor, did it come with instructions ? If so, read it. It says. If not, the thing between the motor cradle and the motor itself.
|
ohh i know what you meen but thats not the problem the motor will shut off
|
What do you mean shut off ? Please try and be more detailed about it so I can help you.
|
ok i will keep hitting the gas and the motor want make a sound lol but if i spin spin the armature a few spins it will come back to life then die and then nothing
|
What ? I barely understood that. Try and use puncuation.
From what I got from it, just change the batteries for fresh ones. How can you spin the armature while the motor is installed ? If you mean the wheels, does something feeling like it's binding or is it free to spin ? |
i just charged the batteries again and sorry yeah i took the motor out of its case and just kept the wires in the car. Its like the motor is binding because if i spin the armature it trys to run then it stops. hope some of this is helping you out
|
Does the armature spin free when you spin it ? I would say open it up and check the stuff inside, but I'm not too sure that you'll be able to put it back together. Or this might be a manufacture defect and just exchange it.
|
yes it spins just fine yeah i guess i will try and take it back then.
Thanks for your help. |
did you use too big of a gear, thats what i did and got the same results. sometimes biger is not better
|
dude read the rules! this thread is months old!
where are the mods these days???? |
here is my two cents
1. the motor armature shaft could be bent 2. there could be something in the motor 3. the motor could just be plain faulty |
All times are GMT -4. The time now is 05:46 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.