help. im new!
 

ok ive had noob problems with the gen 1 chassy. and i tend to break wires and not know how to fix. but ive done some reasearching cuz i am new to the electronics. but i now have a basic knolledge. but ill cut to the chase.. i wuz just wondering wut would happen or if it worked if i soldered the batt pack wires to a male or female end of a connector off of a board or a stock motor layin around. would it have an effect on the output? and also i have had problems with my steering not bein so good if i dont use my gen after so long. i have one gen 1 kinda working but i dunno if it duz that cuz the servo motor or fets are fried or wut. and right now i have minimum access to ordering new parts. and i could use the knolledge so i know how to do it later down the road.

thanks ND56

EDIT: if it you all prefer pics i could take some tomorrow and post them so you have a better idea of wut im trying to say. i try to explain the best i can

thanks. and yeah i know its pointless it wuz just kind of more of a practice think with soldering and stuff. but whats the max volts for a stock gen 1? and would it fry my steering fets?

7.4v is it for the Gen 1's. Anymore and you risk blowing the FETs.

ok thanks guys