gen1 /evo board swap
 

Is possible to swap a gen1 board with an evo one?????
cause I tried, all the wires match up, but the servo keeps cuting hard right.
But the engine works fine, has a lot of pwr.

You want to put the evo board into a gen1 right?? Or other way round?? If the first its easy, if you search around I did it and I'm pretty sure I documented the wiring sequence if you can't find my Civic I know others have done it....

Is there any way u can post a link

if you look at the wires on a stock gen 1 and a stock evo and compare them it wil be easy to figue them out

I tried that but the wires are all diff. colors.

Sounds like the wires need swapping on the servo leads. Try swapping the motor connections first and test...if that doesn't solve change the pot wire connections and test.

U mean were the wires hook to the servo?

Ok I know they are diff colors but if you look at where they go and compare you'll find it out easy

I have tried hookin them all different way....and still they don't. Work...
I think maybe my servo is no good.....but it works in the gen 1 .....:-?
I am about to get mad and slamm the whole darn thing into rhe wall:guns: :uzi: :cussing: :mad:

OK here you... took me ages to find this as a lot of my images are broken....

http://i250.photobucket.com/albums/g...66-gevo008.jpg

Does it help??

Thanks so much b1g I got it:cheers:

http://i1191.photobucket.com/albums/...926_205935.jpg

http://i1191.photobucket.com/albums/...926_205948.jpg

http://i1191.photobucket.com/albums/...926_205948.jpg

http://i1191.photobucket.com/albums/...926_210127.jpg


I just got done driving my xmod with the swaped board.....and already an accident ...


http://i1191.photobucket.com/albums/...926_230247.jpg

http://i1191.photobucket.com/albums/...926_230335.jpg

http://i1191.photobucket.com/albums/...926_230446.jpg