i kould use a little help
does anyone know how to wire a micro-t pcb to an xmods?? also is there a wiring diagram for the micro-t esc?
|
there might be one floating around in the forums. try the search function for "micro-t board swap"
i vaguely remember there being one, but don't remember which section of the forum its in. |
ckouldnt find one
|
2.8 did this for my bros car
Quote:
|
i know the steering and stuff i need to know where the power, motor, etc wires go.
|
Well if you have the board in front of you the farthest fet is negative then the one next to it is positive these are for the motor and the solder point next to that fet is the positive terminal for the battery and right next to that is the negative one does this help any?
|
yes actually. thanls and do i have to solder anything else to the board??
|
Nope the servo is just a plug that goes in and if the motor spins backwards just switch the motor wires if you look at the pics of my bros car you can see the wires were switched because this board didn't run the same way as his other one
|
what about the power switch or something. i see solder contacts on the bottom.
|
All soldering for the motor and batterys are on the side of the board with the crystals and you can get rid of the power switch just solder a jumper wire from the positive to negative solder points on the board for the switch it basicly just gives it a complete circuit so it doesnt have to be controled
|
okay ckool kan i use a mini-z remote and xmods crystals with this ESC??
|
The crystals are a yes but the remote im not sure on you may have to buy a losi one
|
oo okay thankss alot
also for future reference it does work with mini-z remote and xmods crystals. |
All times are GMT -4. The time now is 04:08 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.